De Angeli Prodotti has developed the process to give a rough surface on the conductor to make it hydrophilic.
“Inspired by Silence“
Generally the conductor is not treated and can be either hard or annealed aluminium. The surface doesn’t have a specific treatment and the conductor is quite easy to produce.
For a particular request from one costumer, De Angeli Prodotti accepted the challenge to produce a hydophilic conductor. After one year of research and development, all the parameters were met and defined and a new production line installed in the factory.
One solution for different problems.
De Angeli Prodotti has developed the process to give a rough surface on the conductor. The untreated conductor is hydrophobic, because of the presence of a thin layer of drawing oil on the surface.
The sandblasting phase has the purpose to remove the oil and to give the correct surface roughness.
The process is well-known and treatment is uniform on the whole surface. We can use different kind of sand (corundum or steel) and different mesh to reach the costumer specifications.
Why should you choose to sandblast the conductor? There are different reasons. If you sandblast the conductor you will have an increase of emissivity, i.e. more ampacity at the same operating temperature!
If you sandblast the conductor, you will have an hydrophilic surface on conductor. This characteristic is important for the corona effect. Some studies show that there is a reduction in noise of about 7dB.
Figure 1. Water drop on a hydrophobic conductor (left) and on a hydrophilic conductor (right)
De Angeli Prodotti has developed this surface treatment to improve the characteristic of conductors both for HTLS and for traditional conductors (AAAC, ACSR).
This technology is well known to us and is available for marginal expense.